On Thu, May 22, 2014 at 2:53 AM, Paventhan K <[email protected]> wrote: > Hi Daiane, > I have already enabled flexcan by applying a patch to > imx6q-sabresd.dts file. I am able to get the flexcan driver up and configure > it. I am not understanding why does the bus state goes off even when the > imx6q sabresd board's can transreceiver(TJA 1040T) is connected to the vector > can. It would be very helpful even if you tell me how I can go about > debugging it. I have tried using a DSO to check if I can see the transmission > signal on TX. But when I connect the probe to CAN_H and CAN_L of the > transreceiver I see nothing. I have also noticed that the "stby pin" of the > transreceiver always remains high(3.5V). Will I have to apply any patch to > somehow make it low and then run the transreceiver in normal mode instead of > standby mode? >
Have you already posted your question on imx.community? This mailing list is not supposed to be used for kernel support.... I don´t have enough hardware to test it on my side, sorry. > This Email may contain confidential or privileged information for the > intended recipient (s). If you are not the intended recipient, please do not > use or disseminate the information, notify the sender and delete it from your > system. OPS next time, try to not send this kind of text appended in your email =P Daiane -- _______________________________________________ meta-freescale mailing list [email protected] https://lists.yoctoproject.org/listinfo/meta-freescale
