Hi,
I have prepared an Yocto SD card image
"core-image-minimal-imx6q-sabresd.sdcard". I trying to flash the image onto
sdcard using the command
"sudo dd if= core-image-minimal-imx6q-sabresd.sdcard of=/dev/sdb bs=1M"
Sync
Sync
I m getting the boot messages as below
U-Boot 2014.10+fslc+g5fd0b60 (Apr 03 2015 - 18:55:01)
CPU: Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: MX6-SabreSD
I2C: ready
DRAM: 1 GiB
MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
*** Warning - bad CRC, using default environment
No panel detected: default to Hannstar-XGA
Display: Hannstar-XGA (1024x768)
In: serial
Out: serial
Err: serial
PMIC: PFUZE100 ID=0x10
Net: FEC [PRIME]
Hit any key to stop autoboot: 1
I m stuck up badly. It is not going further. Does the sdcard image contain
ΓΌ-boot, kernel image and rootfs ? or should I flash u-boot separately ? I even
tried flashing both u-boot and sdcaed image. But getting same messages.
Request help in this regard.
Thanks & Regards
Shalini K P
L&T Technology Services Ltd
www.LntTechservices.com<http://www.lnttechservices.com/>
This Email may contain confidential or privileged information for the intended
recipient (s). If you are not the intended recipient, please do not use or
disseminate the information, notify the sender and delete it from your system.
--
_______________________________________________
meta-freescale mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/meta-freescale
