Hi,
I'm trying to get FlexCAN driver to work in imx6q-sabre-sdb - develboard
without any success.
I have added FlexCAN driver as a module in kernel config as well as the other
CAN-devices/drivers needed (can,can-dev, can-raw).
Also I added to arch/arm/boot/dts/imx6q-sabresd.dts following lines:
----
&flexcan1{
status = "okay";
};
----
After recompiling kernel and programming it to device, when I modprobe flexcan
- module nothing happens. It doesn't print that flexcan is found and when I add
the other CAN-modules and try to access CAN0(or CAN1) they claim that there is
no such device. I've worked with FlexCAN in imx537 so I'm somewhat familiar how
to access it, but problem is that it does not show up at all.
Is there something else needed to do to get FlexCAN working with imx6q? I did
search the internet, but didn't find anything else what should be done.
Yocto version is 1.7.1 and kernel version is linux-imx-rt-3.10.17.
Teemu Keskinarkaus
Software system engineer
Cell: +358 400 330047
Fax: +358 207 669199
www.maximatecc.com<http://www.maximatecc.com/>
maximatecc
making machines smart, safe and productive
________________________________
Actuant Corporation Email Notice
This message is intended only for the use of the Addressee and may contain
information that is PRIVILEGED and/or CONFIDENTIAL.
This email is intended only for the personal and confidential use of the
recipient(s) named above. If the reader of this email is not an intended
recipient, you have received this email in error and any review, dissemination,
distribution or copying is strictly prohibited.
If you have received this email in error, please notify the sender immediately
by return mail and permanently delete the copy you received.
Thank you.
--
_______________________________________________
meta-freescale mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/meta-freescale
