Hello Thomas, In u-boot environment, you don't set the "consoledev" variable. Please set this variable and try again.
Best Regards, Zhenhua > -----Original Message----- > From: [email protected] [mailto:meta-freescale- > [email protected]] On Behalf Of Thomas A. F. Thorne MEng AUS MIET > Sent: Thursday, August 25, 2016 8:53 PM > To: [email protected] > Subject: [meta-freescale] Getting Started With A New freescale / NXP LS1021- > TWR > > Good afternoon, > > Has anyone got a kernel from a recent release to come up on a recently > produced LS1021TWR board? I have been struggling to get an LS1021-TWR > board booting from images that I have generated using the community > freescale. I have also tried to use the freescale SDK for the board without > much success, so it seems likely there is some common fault, probably with my > configuration, if not the hardware or pre-loaded binaries. > > I ask specifically about it being a recently produced board as it sounds as > if the > CPU has been updated and may not work as it did before. This is based off of > some discussions I had with a distributor over the past couple of weeks. > Initially I thought this was something causing an issue with just the > LS1021-IOT > boards and their SDKs but it sounds like both Internet Of Things and ToWeR > designs are effected. > > I had made a post about my difficulties on the NXP Community site, but not > received any comments on it yet. > https://community.nxp.com/thread/432937 The post includes a summary of > my issue, the environment variables that I have set and the serial output from > the board. I can provide further details through this mailing list too, but > I did > not want to generate a huge email full of what might be irrelevant data. The > short summary is that I get as far as the "Starting kernel ..." message and > then > see no further output from the board. This is true when trying to boot from > the SD card or over NFS. > > If anyone can provide any suggestions or pointers I would be very grateful to > hear them. > > Regards, Thomas > > -- > Thomas Thorne Software Engineer Net2Edge Limited > Tel: +44 3450 130 030 > Email: [email protected] > Web: http://www.Net2Edge.com/ > > Net2Edge Limited is a company registered in England & Wales (Company No. > 2438435, VAT No. GB 537553821) Passfield Oak, Liphook, Hampshire, GU30 7RL. > This email transmission is confidential and intended solely for the person or > organisation to whom it is addressed. If you are not the intended recipient, > you > must not copy, distribute or disseminate the information, or take any action > in > reliance of it. Any views expressed in this message are those of the > individual > sender, except where the sender specifically states them to be the views of > any organisation or employer. If you have received this message in error, do > not open any attachment but please notify the sender (above) and delete this > message from your system. Please rely on your own virus check. Although all > outbound mail is checked for viruses, no responsibility is taken by the sender > for any damage rising out of any bug or virus infection. > -- _______________________________________________ meta-freescale mailing list [email protected] https://lists.yoctoproject.org/listinfo/meta-freescale
