Nevermind. You are right. I made the mistake of assuming that the
nitrogen behaves like the Sabre board (= that it reads the u-boot from
the SD card). When I boot, it indeed is a U-Boot version from 2014. I'll
upgrade.
On 2016-08-27 07:19, Carlos Rafael Giani wrote:
Hm.
I let bitbake generate the entire image. That is, rootfs+boot
partition+partition table+u-boot in one file, which I copied over to
the SD card with dd.
Plus, the current u-boot version in meta-fsl-arm-extra is actually
2016.03:
https://github.com/Freescale/meta-fsl-arm-extra/blob/master/recipes-bsp/u-boot/u-boot-boundary_git.bb
On 2016-08-27 01:44, Eric Nelson wrote:
Hi Carlos,
On 08/26/2016 12:11 PM, Carlos Rafael Giani wrote:
Hello,
I just built an image for the nitrogen6x with poky, meta-openembedded,
meta-fsl-arm, meta-fsl-arm-extra, meta-fsl-demos all at the latest
master. boundary-kernel version is 4.1.15.
Looking at /dev/ shows that there is no /dev/fb0, fb1, or any fbX
device
node!
I suspect that you need to upgrade your U-Boot.
The latest from Boundary is v2016.03:
https://boundarydevices.com/u-boot-v2016-03/
There are some notes in the section labeled "New Features" here
about how to use U-Boot to configure your display(s):
https://boundarydevices.com/compiling-latest-u-boot-for-i-mx6-2015-edition/
Regards,
Eric
--
_______________________________________________
meta-freescale mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/meta-freescale
