Dear All,

I am trying to implement "Wi-Fi Access Point" on the IMX7 evaluation board 
having Murata Wi-Fi chip(LBEH5HMZPC).

Below are my changes in .config file.

CONFIG_BCMDHD_FW_PATH="/lib/firmware/bcm/ZP_BCM4339/fw_bcmdhd_apsta.bin"
CONFIG_BCMDHD_NVRAM_PATH="/lib/firmware/bcm/ZP_BCM4339/bcmdhd.ZP.SDIO.cal"

CONFIG_HOSTAP=y
CONFIG_HOSTAP_FIRMWARE=y

but when I do "ifconfig wlan0 up" I am getting following error

root@imx7dsabresd:~# ifconfig wlan0 up

Dongle Host Driver, version 1.141.92 (r)
Compiled in drivers/net/wireless/bcmdhd
wl_android_wifi_on in
mmc1: queuing unknown CIS tuple 0x80 (2 bytes)
mmc1: queuing unknown CIS tuple 0x80 (7 bytes)
mmc1: queuing unknown CIS tuple 0x80 (6 bytes)
F1 signature OK, socitype:0x1 chip:0x4339 rev:0x1 pkg:0x0
DHD: dongle ram size is set to 786432(orig 786432) at 0x180000
dhd_bus_init: enable 0x06, ready 0x06 (waited 0us)
dhd_bus_rxctl: resumed on timeout, INT status=0x208000C0
dhd_bus_rxctl: rxcnt_timeout=1, rxlen=0
dhd_check_hang: Event HANG send up due to re=1 te=0 e=-110 s=2
dhd_open : wl_android_wifi_on failed (-14)

What could be the issue?
Note: Wi-Fi is working fine in client mode. It can able to scan and all.

possible issue may be

1) I think I have missed some patches as mentioned in the document 
(http://www.nxp.com/docs/en/application-note/AN5414.pdf)
Can I get the patches as mentioned in ("section :2 Prepare source code for 
applying Wi-Fi patches" from doc 
http://www.nxp.com/docs/en/application-note/AN5414.pdf )


Please help me to resolve the issue

Thanks and Regards,
Vikram

________________________________

SASKEN BUSINESS DISCLAIMER: This message may contain confidential, proprietary 
or legally privileged information. In case you are not the original intended 
Recipient of the message, you must not, directly or indirectly, use, disclose, 
distribute, print, or copy any part of this message and you are requested to 
delete it and inform the sender. Any views expressed in this message are those 
of the individual sender unless otherwise stated. Nothing contained in this 
message shall be construed as an offer or acceptance of any offer by Sasken 
Technologies Limited ( formerly known as "Sasken Communication Technologies 
Limited" ) unless sent with that express intent and with due authority of 
Sasken. Sasken has taken enough precautions to prevent the spread of viruses. 
However the company accepts no liability for any damage caused by any virus 
transmitted by this email.
Read Disclaimer at http://www.sasken.com/mail-disclaimer/

________________________________
-- 
_______________________________________________
meta-freescale mailing list
meta-freescale@yoctoproject.org
https://lists.yoctoproject.org/listinfo/meta-freescale

Reply via email to