U-Boot is now used with SPL, set the machine conf file accordingly. Signed-off-by: Max Krummenacher <max.krummenac...@toradex.com> --- conf/machine/apalis-imx6.conf | 15 +++++++-------- 1 file changed, 7 insertions(+), 8 deletions(-)
diff --git a/conf/machine/apalis-imx6.conf b/conf/machine/apalis-imx6.conf index 8992047..f5bcf38 100644 --- a/conf/machine/apalis-imx6.conf +++ b/conf/machine/apalis-imx6.conf @@ -16,14 +16,13 @@ KERNEL_IMAGETYPE = "uImage" PREFERRED_PROVIDER_u-boot ?= "u-boot-toradex" PREFERRED_PROVIDER_virtual/bootloader ?= "u-boot-toradex" -# Modules in commercial and industrial temperature range have different RAM. -# Using apalis_imx6_it_defconfig builds an U-Boot working for both temperature -# ranges, however, on commercially rated modules the RAM bandwidth is 5-10% -# higher when using the optimized settings from apalis_imx6_defconfig. -# The following builds both binaries, but uses the IT one in an SD image. -UBOOT_CONFIG ??= "it" -UBOOT_CONFIG[com] = "apalis_imx6_defconfig" -UBOOT_CONFIG[it] = "apalis_imx6_it_defconfig" +SPL_BINARY = "SPL" +# The SPL configures the DDR RAM depending on the module it runs on. Thus there +# is no need to distingush between the different module types. +UBOOT_CONFIG ??= "spl" +UBOOT_CONFIG[spl] = "apalis_imx6_defconfig,,u-boot.img" +UBOOT_MAKE_TARGET = "" +UBOOT_ENTRYPOINT_use-mainline-bsp = "0x10008000" IMAGE_FSTYPES = "sdcard.gz tar.xz" -- 2.9.4 -- _______________________________________________ meta-freescale mailing list meta-freescale@yoctoproject.org https://lists.yoctoproject.org/listinfo/meta-freescale