On 07/08/12 18:41, Koen Kooi wrote:

Op 7 aug. 2012, om 18:36 heeft Jack Mitchell <[email protected]> het 
volgende geschreven:

On 07/08/2012 16:53, Denys Dmytriyenko wrote:
On Tue, Aug 07, 2012 at 04:44:49PM +0100, Richard Purdie wrote:
On Tue, 2012-08-07 at 11:38 -0400, Denys Dmytriyenko wrote:
On Tue, Aug 07, 2012 at 05:32:36PM +0200, Koen Kooi wrote:

Op 7 aug. 2012, om 17:30 heeft Denys Dmytriyenko <[email protected]> het volgende 
geschreven:

On Tue, Aug 07, 2012 at 10:02:24AM +0100, Jack Mitchell wrote:
I am trying to turn of CONFIG_SPI_DEBUG in the beaglebone BSP from
meta-ti. I am using the poky distro configuration and I have changed
the defconfig in
meta-ti/recipes-kernel/linux/linux-ti33x-psp-3.2/beaglebone/defconfig
but it still builds with CONFIG_SPI_DEBUG enabled.

That should be the correct location, please make sure you re-do the unpack
task - if you previously built the kernel with the old defconfig, it will be
stored in the work directory and won't be copied from the repository above,
until you repeat the do_unpack task, i.e. by clenaing the build.

BTW, no need to clean the entire build, just the kernel build:

$ bitbake virtual/kernel -c clean

Or just increment PR as you're supposed to, it's an output change after all.
No need to check anything if you do it properly :)

Well, but then you are staring to change the recipe, which might be overkill
for a simple defconfig change you want to test. If you go that route, you may
want to create your own custom layer with the modified defconfig overlayed on
top of meta-ti and a simple .bbappend with PRINC. That way your changes will
be detached from meta-ti and you won't need to merge the recipe changes every
time meta-ti updates... Although, there's no way to bbappend the defconfig
itself - that's where config fragments come to play.

With the recent changes to OE-Core, you can edit the defconfig, the
system will notice the checksum change and automatically rerun the
unpack and subsequent steps automagically.

Richard,

That is quite useful, thanks for the info!


If the PR server is enabled, it will bump PR for you too.

That is something I haven't looked at yet, honestly - too much Classic-OE
baggage to carry... :)


Well, this thread took off when I turned my back!

Thanks for all the advice and different solutions - I found what my issue was 
and it is that the BeagleBone was booting using the kernel on the rootfs rather 
than the kernel in the fat partition as I believed. So I was only replacing the 
FAT partition uImage and not re-building and copying the whole rootfs.

Next step is indeed to have an overlay so I can customize the kernel config a 
bit more, along with a patch or two I have in there.

Please post the patches, they might be generally usefull. I don't know why spi 
debug is on, I'm not opposed to turning it off :)

Someone beat me to it, I'm not running the latest master so it seems I'm a bit out of sync with the world.

--

  Jack Mitchell ([email protected])
  Embedded Systems Engineer
  http://www.embed.me.uk

--

_______________________________________________
meta-ti mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/meta-ti

Reply via email to