On Tue, May 17, 2016 at 8:20 AM, Alistair Francis <[email protected]> wrote: > On Mon, May 16, 2016 at 9:39 AM, Alistair Francis > <[email protected]> wrote: >> On Sun, May 15, 2016 at 10:10 AM, Peter Crosthwaite >> <[email protected]> wrote: >>> On Sun, May 15, 2016 at 1:17 AM, Nathan Rossi <[email protected]> >>> wrote: >>>> On Sat, May 14, 2016 at 2:54 AM, Alistair Francis >>>> <[email protected]> wrote: >>>>> On Fri, May 13, 2016 at 2:35 AM, Nathan Rossi <[email protected]> >>>>> wrote: >>>>>> On Fri, May 13, 2016 at 6:11 AM, Alistair Francis >>>>>> <[email protected]> wrote: >>>>>>> Add the qemuzynqmp machine based on the physical ZCU02 revB board. >>>>>> >>>>>> Hi Alistair, >>>>>> >>>>>> So I am a little confused, is this machine supposed to emulate the >>>>>> ep108 (the args to QEMU appear to be for the ep108) or the zcu102? or >>>>>> are both able to be emulated? >>>>> >>>>> Hey Nathan, >>>>> >>>>> This machine is supposed to be emulating the ZCU102. >>>>> >>>>> At the moment we only have the EP108 in upstream QEMU. It isn't worth >>>>> adding a ZCU102 model upstream yet as at the moment we don't have >>>>> enough modeled upstream to notice any differences between the boards. >>>> >>>> Ah ok, so in the future QEMU will have models for both the EP108 and >>>> the ZCU102 boards. In that case I don't actually see a need for a >>>> 'qemuzynqmp' machine, since the ep108-zynqmp already provides the >>>> setup for QEMU. The same can be done for the zcu102-zynqmp board, this >>>> would also make it easier to maintain consistency (aka changes only >>>> need to be made to the zcu102-zynqmp machine). >>>> >>> >>> +1, qemuzynq as well as the "zynq" machine model in upstream QEMU are >>> legacy convention that we should replace with concrete boards going >>> forward. >> >> Ok, I'll look into adding a ZCU102 machine similar to what we do for the >> EP108. > > How can I run the EP108 on QEMU? I can't find how I can start QEMU with Yocto.
There is no runqemu support though the ep108 machine is setup to build qemu-native for use. But there was a guide created back when first adding zynqmp, essentially it is manually running QEMU with the correct args. http://www.wiki.xilinx.com/Yocto+for+zynqmp Regards, Nathan > > Thanks, > > Alistair > >> >> Thanks, >> >> Alistair -- _______________________________________________ meta-xilinx mailing list [email protected] https://lists.yoctoproject.org/listinfo/meta-xilinx
