That explains the bug I had in the installer.
Thanks!!!
---------------------=---------------------
Xavier Bury
TNS NT LAN Server
ext 6465
| Robert Brenstein <[EMAIL PROTECTED]>
Sent by: [EMAIL PROTECTED] 10/09/03 09:24
|
To: [EMAIL PROTECTED] cc: ^ Subject: Re: Clone stack invisibly |
>Just make the stack not visible before cloning it.
>
>Tested in the Script Editor installer... For a later release! ;)
>
I can confirm that this works. However, a word of caution: when a
stack opens invisible, it does not get all of the normally expected
"open" messages (behavior confirmed by Scott Raney so not considered
as a bug so far).
Robert Brenstein
_______________________________________________
metacard mailing list
[EMAIL PROTECTED]
http://lists.runrev.com/mailman/listinfo/metacard
Visit us at http://www.clearstream.com
IMPORTANT MESSAGE
Internet communications are not secure and therefore Clearstream International does not accept legal responsibility for the contents of this message.
The information contained in this e-mail is confidential and may be legally privileged. It is intended solely for the addressee. If you are not the intended recipient, any disclosure, copying, distribution or any action taken or omitted to be taken in reliance on it, is prohibited and may be unlawful. Any views expressed in this e-mail are those of the individual sender, except where the sender specifically states them to be the views of Clearstream International or of any of its affiliates or subsidiaries.
END OF DISCLAIMER
