List, I think Jason has done a fine job with his position with which I agree. I 
don't want to beat a dead horse but Here are  published  definitions of fusion 
crusts on irons.

  “Fusion Crust” Definition from Glossary of Geology 2nd edition 1980; American 
Geological Institute, Falls Church, Virginia, 751pp.
 
Fusion crust  A thin glassy coating, usually black and rarely exceeding one 
millimeter in thickness, formed on the surface of a meteorite by frictional 
heating during atmospheric flight.
Owing to differing effects of the atmosphere upon different meteorite surfaces, 
fusion crusts may be knobby, striated, ribbed, net, porous, warty, or 
scoriaceous.

Several points stand out upon careful reading of this definition. The term 
glassy is an adjective not a noun. Glassy is a term commonly used in describing 
surface luster in mineralogy. Composition: Silica, silicate, silicon and iron 
are not mentioned at all. Apparently composition is not pertinent to the 
matter. Other terms like warty and seem to refer to fusion crust on irons.

Looking further for definitions used specifically by meteoriticists we find a 
definition on pages 44-45 by Brian Mason in his classic book, “Meteorites”. 
Mason presents the classification of Krinov (1960) that also seems to have been 
a source for the Glossary’s definition. It is rather long but I will post the 
complete definition because many people have complained there wasn’t a good 
published definition of fusion crust for meteorites.

Fusion Crust

A freshly fallen meteorite is covered with a fusion crust, except on fracture 
surfaces produced on or shortly before impact. The nature of the fusion crust 
varies somewhat, according to the composition of the meteorite. On most 
meteorites it is black, but on the enstatite achondrites it is colorliess or 
pale yellow, because of the almost complete absence of iron in these 
meteorites. The fusion crust on iron meteorites is very thin, only a fraction 
of a millimeter, and consists of magnetite. The fusion crust on stone 
meteorites is thicker, and consists of a black glass which includes fragments 
of the less fusible mineral such as olivine. On chondrites and the calcium-poor 
achondrites the crust is usually dull, but on calcium-rich achondrites, which 
are more fusible than other stony meteorites, the crust is shiny and lustrous, 
and also thicker than on other types. Sometimes the crust shows a network of 
fine cracks, similar to the “crazing” which appears in the glaze of pottery. 
Krinov (1960) has made detailed studies of the nature of meteorites, and 
presents the following classification:

Class I.  Crust of Frontal Surfaces

Type 1, Close-textured.  The crust is perfectly smooth, as though it had been 
pressed, with practically no indications of structure. Observed mainly upon 
iron meteorites and covers surfaces, which generally exhibit considerable marks 
of atmospheric action, regardless of whether the surface has regmaglyptic 
relief.

Type 2, Nodular.  Upon a smooth, close textured crust, fine angular nodules are 
visible scattered over the surface of the meteorite. Upon stony meteorites, on 
which this type is mainly found, the nodules represent fused inclusions of 
nickeliferous iron. 

Class II.  Crust of Lateral Surfaces

Type 1.  Striated.  Upon a smooth, close-textured crust thin striae are visible 
that seem to be flowing across the surface of the meteorite.
Very often the striae are directed toward the rear part of a meteorite, thus 
clearly indicating the direction of its motion.  Upon iron meteorites the 
striae quite often end in drops, which are sometimes of spherical form. There 
are also observed curves or even seemingly broken striae which abruptly change 
direction. Now and then an intricate pattern of the striated crust can be seen. 
 In rarer cases several systems of striae are observed, superimposed one on top 
of the other and intersecting at various angles.  In such cases the striae of 
the bottom system appear to be wide and flat, while those of the upper system 
are thin.
Particularly sharply defined striated crustal structure is observed near the 
sharp edges of lateral surfaces, adjacent to the rear surfaces of iron 
meteorites.  Upon stony meteorites more or less distinct striae are usually 
observed along the edges of lateral surfaces.  Striae are easily 
distinguishable on the rims between regmaglypts.

Type 2.  Ribbed.  Represents an intermediate type between the modular and 
striated crust and is found only upon stony meteorites. The ribs appear like 
underdeveloped striae.

Type 3.  Net.  The crust is formed of short striae running together, lending it 
the appearance of a fine-mesh net. Individual cells of the mesh appear like 
stitches.  Is observed mainly upon more friable stony meteorites, usually near 
the edges of lateral surfaces or near protuberances.

Type 4.  Porous.  At magnification of 15-30X tiny pores can be seen clearly 
upon the crust. Sometimes the crust appears to be sintered.  This effect is 
observed upon iron as well as upon stony meteorites in the vicinity of the 
edges of the lateral surfaces, which make no sharp borders with the rear 
surfaces, It is also observed within various depressions on the surfaces.

Class III.  Crust of Rear Surfaces

Type 1.  Warty.  This type of crust is particularly prevalent and sharply 
defined upon iron meteorites, and on large meteorites it is clearly visible 
with the naked eye.  Under a magnifying glass, a close texture can be seen made 
up of individual warts, covering the surface of the meteorite. Each node 
represents a group of finer nodules which are partly fused together. Quite 
often among the nodes single globules can be seen of perfect spherical form.

Warty structure upon stony meteorites is as a rule considerably less distinct 
and is encountered only rarely. It is observed primarily within depressions or 
along the edges of rear surfaces.

Type 2. Scoriaceous.  This type of crust is found primarily among the stony 
meteorites, for which it seems to be characteristic.  Upon iron meteorites the 
scoriaceous crust is observed only on single portions and in the vicinity of 
sharp edges or near protuberances.  The scoriaceous crust has the appearance of 
clinkered slag.

“Fusion Crust” Definition from: Mason, B.,1962: “Meteorites” John Wiley and 
Sons, New York and London, 274pp.

Regards, Fred Olsen



______________________________________________
http://www.meteoritecentral.com
Meteorite-list mailing list
[email protected]
http://six.pairlist.net/mailman/listinfo/meteorite-list

Reply via email to