I don't believe any of the ".fmt" files have been modified. If they have been it was inadvertent. While looking around in the c:\sm9\mill\josdef & josrpt folders I did discover copies of these ".fmt" files with the .old file extension. These "old" files had their names all in caps (significant?). I printed out both the fmt & old versions of these files and they appear identical. Where can I find the original ".fmt" files on the SmartCAM disk? P.s. Now the Job Info report isn't working as well, however the step info report does still work.
Patrick M. Haran Gasser Engineering 440 Moreland Road Commack, New York 11725 ph: 631.543.6600 x 217 fx: 631.543.6649 web: www.gasser.com -----Original Message----- From: Joe Noard [mailto:[EMAIL PROTECTED]] Sent: Friday, 14 January, 2000 11:01 AM To: Patrick Haran Subject: Re: [mfg-smartcam] RE: Patrick: I seem to remember your problem from a while back. I have a few questions to qualify tho. Did you modify the files that control the job reports in any way? Have you renamed the files and use the renamed files? The problem that I encountered was the syntax in the edited files must be perfect or the system "ignores" the file when you try to print. Recommendation: Use the original files supplied with the software as a test, and if they print, then start to modify until it fails. That way you know the last thing you did is the culprit. Later: Joe Noard ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
