Your right John, size does matter. It appears that if the length of either of the elements exceeds 10000 beyond the point of intersection, the trim/extend will fail. This is too bad, this is for a metric bridge girder macro.
============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] http://www.highsteel.com ============================================= -----Original Message----- From: John Gent [mailto:[EMAIL PROTECTED]] Sent: Wednesday, February 02, 2000 3:32 PM To: Lauzus, Frederick Cc: SmartCAM Email Group Subject: Re: [mfg-smartcam] Cant trim Fred, I've heard of this before many moons ago. It has to do with their size. Try scaling them down first, then trim, an rescale. "Lauzus, Frederick" wrote: > Here's a stumper. The attached file contains 2 lines created on layer 1. I > cannot trim these using Geo_Edit, Trim/Extend. an error message is displayed > telling me the elements do not intersect. It acts the same in milling or > fab, inch or metric. Is this a bug, or am I missing something? > <<cant trim.pm4>> > > ============================================= > Fred Lauzus, CAM Programming Coordinator > High Steel Structures, Incorporated > mailto:[EMAIL PROTECTED] http://www.highsteel.com > ============================================= > > ---------------------------------------------------------------------------- ---- > Name: cant trim.pm4 > cant trim.pm4 Type: unspecified type (application/octet-stream) > Encoding: base64 -- John Gent Structural Dynamics Research Corporation Americas Support Center - Eugene The secret of life is nothing at all. - Gretchen Peters ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
