SmartCAM doesn't support the G71, G72 & G73 multiple pass roughing cycles. The cycles that are supported are the single pass cycles such as the G90 & G94 cycles found on a Fanuc control. These cycles are only called when using horizontal or vertical single line passes in your roughing process. They do not support any contours or overlap passes.
============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] http://www.highsteel.com ============================================= -----Original Message----- From: David Shultz [mailto:[EMAIL PROTECTED]] Sent: Thursday, March 02, 2000 10:13 AM To: [EMAIL PROTECTED] Subject: [mfg-smartcam] Lathe Turn Can Cycle Well here we go again. Adv Turn V11.5 I am trying to set up a CCG for a G71 Rough Turn cycle. I have question 180 set to yes. I also have an @OP_TURN in my tmp file. Does anyone have a CCG as an example they could send me? I need to fill in Stock amounts, depth of cut. I know we can't get start and end block numbers as I can add them after the code is done. Can I do a Turn-Rough and have it fill in the fields needed for the can cycle? Thanks for the help David Shultz Advanced CAM Technology 3143 W 33rd ST Cleveland, Ohio 44109 216.961.1455 fax 216.961.4809 [EMAIL PROTECTED] ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
