Steve, Check to see that you don't have a filter active. Also check to see if you are using a workplane other than the XY_Plane.
Gene Bowen SMARTCO Steve Buck wrote: > Hello experts: > I am having snap problems. I am using ver 11.5 of production milling and > only working in 2D waterjet programming. I always have my geometry on Z > zero and on the XY-Plane. My snap to point or end of element will not > work. It is snapping wildly and all over the screen. It has been working > fine and I haven't been tinkering with any settings. > > INCREMENTS SETTINGS > Linear increment 0.0100 > Angular increment 1.000 > Snap pick 30 > Automatic pick 3 > Z off > > What's up??? > > Steve > ATM > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
