Hi All, I don't know if this is what you're after; but if I want to change the rev. level of a job, I open the .jof file in Wordpad, in the "header section", and change rev = "?" to the rev level I want. Worked good so far.
Kevin -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Tuesday, April 11, 2000 9:49 AM To: [EMAIL PROTECTED] Subject: Re: [mfg-smartcam] revisions Hi Colin... Try this... File, Save JOF file, (rename to ie.: job-plan to job-planx by) Save than... File, Load JOF file, (dialog show the same name as saved) Load At the next ordinary save the JOF-file gets the same name as tke PM4-file but is rev.1. T.Holst At 10:45 AM 4/10/00 -0400, you wrote: >PMILL 11.0: >Does anybody know how to reset the "revisions" in the job info page. Every >time you do a save the number increases. > > >Thank You > >Colin Williams >Wabtec Corporation > > > >Attachment Converted: "\\prototech1\postoffic\dap1\attach\jobinfo.xls" > --------------------- PROTOTECH AS P.O. Box 6034 N-5892 Bergen, Norway. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
<<application/ms-tnef>>
