I've used this for years an the Haas's I ran before. I've added some logic that checks the workplane name and if it's anything other than XY it will output the workplane name in place of the G54. That is useful for having parts on another coordinate system that you want to have run but are not sure off the real XY position of it. You can delete taht section if it's not useful, but at least your aware of it.
Ron Klutts > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of Larry Rupe > Sent: Thursday, July 06, 2000 8:19 AM > To: ''Smartcam' (E-mail)' > Subject: [mfg-smartcam] post processor > > > I am looking for a proven post processor, both .tmp and .smf > files, for a > Haas VF series. If anyone has such, could you share it by > email. I do > greatly appreciate it. > > Sincerely, > > Larry Rupe > > [EMAIL PROTECTED] > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > >
m_fanuc.tmp
Description: Binary data
m_fanuc.smf
Description: Binary data
