I believe the little quirks of the Wall Offset command have been discussed in the past but I don't remember anything regarding the "corner roll angle".
Occasionally, the corner roll angle is set at .5 degrees (which results in an error) even though I've saved defaults with the setting at 180. Anyone else experiencing this with pmill 11x? _______________________________________________________ Peter Ruehle Semiconductor Packaging Materials [EMAIL PROTECTED] http://www.sempck.com (914) 273-5500 ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
