So did I! I use Windows NT and I have sticky buttons. However, I just got upgraded Pentium 3 600 HP computer with 256 meg of ram and no more sticky buttons. I was using a Pentium 166 with 64 meg of ram. Hmmm...
-----Original Message----- From: Hopple, Bob <[EMAIL PROTECTED]> To: 'Pete Ruehle' <[EMAIL PROTECTED]>; 'SmartCam Forum' <[EMAIL PROTECTED]> Date: Friday, May 05, 2000 9:45 AM Subject: RE: [mfg-smartcam] icon button madness >I have the same problem noticed it when I switched to NT > >> -----Original Message----- >> From: Pete Ruehle [SMTP:[EMAIL PROTECTED]] >> Sent: Friday, May 05, 2000 12:09 PM >> To: 'SmartCam Forum' >> Subject: [mfg-smartcam] icon button madness >> >> Ok, I know many of you will probably think I've misplaced a few cards from >> my deck, but I find this very amusing: >> >> Very often, when I click on a an icon button, it "depresses" or pushes in >> but fails to pop back out. It gets stuck!!! As if it were a mechanical >> device that is binding. The command does not start with the button "stuck" >> in the in position. I have to click on it again so it "pops" out. >> >> I'm not really looking for a fix or an explanation (although I am >> curious); >> as I said, I find it pretty funny. >> >> >> >> >> _______________________________________________________ >> Peter Ruehle >> Semiconductor Packaging Materials >> [EMAIL PROTECTED] >> http://www.sempck.com >> (914) 273-5500 >> >> ====================================================================== >> To find out more about this mailing list including how to unsubscribe, >> send the message "info mfg-smartcam" to [EMAIL PROTECTED] >> ====================================================================== >====================================================================== >To find out more about this mailing list including how to unsubscribe, >send the message "info mfg-smartcam" to [EMAIL PROTECTED] >====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
