Morning Shawn, all, If I understand correctly, you're going in with a smaller cutter to clean up the corners. When doing a simple "L" shaped cut, the cutter isn't large enough to completely clean the radius left from the previous, larger cutter.
Not sure of which application/version you're using also, but if you are doing a pocket with the first tool, open the Params... dialog and turn on Create Uncut Areas. It should default to layer 99 (this is a good layer because it should be red). Now for the clean up you can "pocket" these areas. Hope that's what you need. Blue Drache wrote: > Good morning, group. > > I've an interesting problem, > I'm making a square inside corner door on a Northwood router with a > Fanuc 18i controller. I'm having trouble with a small "triangle" of > material being left behind near the bottom of the profile. Does anyone > have a program I can put in an .mcl for SmartCAM to knock down that > bump? If not, please give me a push in the correct direction. > > Thanks in advance. > Shawn > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== -- John Gent Structural Dynamics Research Corporation Americas Support Center - Eugene The secret of life is nothing at all. - Gretchen Peters ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
