RE: [mfg-smartcam] Coding a spline.

[Dave Coupar]

As far as I know, Splines code with a combination of Arcs and Lines, depending on the values set in SMF questions 91, 99, and 106.  There may be others...   My .smf is as follows, and I get various G01, G02, and G03 commands to profile a spline.   91. Maximum deviation from true arc: 0.0001 99. Maximum programmable arc radius: 9999.9999 106. Maximum deviation from true curve: 0.0001   Hope this helps,   Coup -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of NLPI Sent: Friday, May 26, 2000 9:13 AM To: SDRC Subject: [mfg-smartcam] Coding a spline. Doe's anyone know how to code a spline using G02/G03(Arc Command) in your CG instead of G01(Line Command).  I am using Advanced Turning V11.5 on a Hardinge T-42 with a Fanuc 18T control.   Any help would be greatly appreciated.   Matt Brightwell