Hey Joe, Not sure what the output is all about, looks like something specific to your code generator.
But did you know that you don't have to set the debug switches in the smartcam.ini file any more? From What's New ... Code Generation Debugging The following flags, which control code generation debug output, now can be entered directly in the @DECLARE section of the code file instead of in the smartcam.ini file. #OUTCND outputs conditional status #OUTSEC outputs @section names #OUTERR outputs processing errors #OUTRPT outputs an error report file Joe Geraci wrote: > Hello Everyone, > > Anybody know what the following represents, it came from a code file > when the debugging switches (smartcam.ini) were set to on. > > <f> > <t>^1^^2^^3^ > > Thanks , > > J.G. > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== -- John Gent Structural Dynamics Research Corporation Americas Support Center - Eugene The secret of life is nothing at all. - Gretchen Peters ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
