RE: [mfg-smartcam] modify line

[McCool Mike-EMM018]

Bill,   Here is a technique that works well. Use Geo_Edit/Split. Set the panel up as follows, Distance Along = 0, From = Mouse, Gap Width = twice the amount of length change. Use a positive Gap Width for a shorter line and use a negative Gap Width for a longer line. Select the line at the end you wish to change. The line will extend or shorten by 1/2 of the Gap Width. This also works for other types of elements. I hope this is of some help.   Good Luck, Mike -----Original Message----- From: Bill Schoeppe [mailto:[EMAIL PROTECTED]] Sent: Tuesday, June 06, 2000 8:41 PM To: SMARTCAM Subject: [mfg-smartcam] modify line does any one know if there is a way to modify the length of a line without doing the endpoints separately.   thanks bill