Chris I am really busy so I didn't pull out the section for you.
I attached my 5 axis *.tmp that does this very thing, it is laid out really nice you should be able to find the section you need. I would like a copy of your *tmp to look it over and maybe get some of the tricks out of it . Thanks Brock If you need the *.smf just ask -----Original Message----- From: [EMAIL PROTECTED] <[EMAIL PROTECTED]> To: [EMAIL PROTECTED] <[EMAIL PROTECTED]> Date: Tuesday, August 15, 2000 8:43 AM Subject: [mfg-smartcam] Rusty post work #2, or should that be <#2>? >My thanks to all who replied to my post question. Using #IFSTR along with >using brackets < > around my conditional output did the trick. > >Now I need another post tweak: When the same drill moves from one workplane >to the next, I need a drill cycle cancel, the conditional workplane output >for the corresponding workplane, then the drill cycle started again, as >follows: >G80 Z1.0 >G68 X____ Y____ R#508 >G98 G83 X____ Y____ Z-____ R0.1 Q0.25 > >As of now, I have never used the @WKSYS section. Do I need to start using >it now? >Any help, as always, would be greatly appreciated. > >Chris > >> >>Chris, >> >>The variable #WKPLN is a string. Use #IFSTR instead of #IF. You are also >>missing the brackets < > around what is to be output if the expression is >>true. >> >>#IFSTR(#WKPLN=G54)< G68 X#XHOME Y#YHOME R#507> >>#IFSTR(#WKPLN=G55)< G68 X#XHOME Y#YHOME R#508> >> >>============================================= >> Fred Lauzus, CAM Programming Coordinator >> High Steel Structures, Incorporated >> mailto:[EMAIL PROTECTED] http://www.highsteel.com >>============================================= >> >> >>>-----Original Message----- >>>From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] >>>Sent: Monday, August 14, 2000 1:47 PM >>>To: [EMAIL PROTECTED] >>>Subject: [mfg-smartcam] Posting conditional output >>> >>> >>>Hi all, >>> I'm a little rusty in my post work, and don't have a lot of spare >time >>>right now to dig deeper, so I'm hoping for a quick hit answer from the >>>forum. I want to test which workplane is active and output specific code >>>for axis rotation. I've tried a few variations on the following with no >>>luck: >>>#IF(#WKPLN=G54) G68 X#XHOME Y#YHOME R#507 >>>#IF(#WKPLN=G55) G68 X#XHOME Y#YHOME R#508 >>> >>>I get both lines output instead of one or the other needed for the active >>>workplane. >>>Any help will be greatly appreciated. >>> >>>Thanks, >>>Chris > > > > > >====================================================================== >To find out more about this mailing list including how to unsubscribe, >send the message "info mfg-smartcam" to [EMAIL PROTECTED] >======================================================================
Complete_3D_Model_5ax.tmp
Description: Binary data
