|
I have the same problem when I code only one tool I get #ntool
in the program but it is already in the spindle. And at the end of the program I
also get an M6 to tool change to the tool that is in the spindle.
Dave Wolfgang
----- Original Message -----
Sent: Friday, September 29, 2000 7:14
PM
Subject: [mfg-smartcam] always
tweeking...
My code comes out so clean from Smartcam that I rarely even
use the text editor. No other software I've used can come close to this
level. But, on rare occasions, only one tool is in the program and
#ntool will output the same tool as is already in use. This causes an
alarm at the nc control if not corrected. Easy enough to fix, but I'm
striving for bug-free code output. How can I get it to... output no tool
pre-call or... get it to pre-call a certain number tool if there's
only one tool in the program?
thanks
dale
|
