|
Howdy all, here are a couple new questions for you
template pros out there.
1) SMF Q.120, code for 1) part profile, 2)
tool center, 3)tool edge
I like the part profile coded,
since it is easier for the machinist to read the code, however..... occasionally
it comes across a radius smaller than the tool nose radius and bombs out the
control. Any way of fixing this via the .TMP file?
2) I have been known to mis-click
occasionally, and I set a fixed drilling tool for SFM, not RPM. What logic
would I need to force all fixed tools to
be output in RPM mode if I make a mistake in the planner?
3) My groove tool always comes out with cutter
compensation (G42, G41) in the code. I have never had much luck with my
control dealing with a groove tool and cutter comp. Any ideas on how to
force only the groove section to come out without cutter comp, and take
groove tool radius into acct when coding that tool?
Thanks guys, any answers on one or all questions
are greatly appreciated.
ps, my .tmp file is included, and yes, its pretty
basic.
Jon Baker
|
Daewoo.tmp
Description: Binary data
