There is probably a missing tool dimension in the old Job Plan. Make sure you have a proper tool length, diameter, corner radius (if applicable), side angle (if applicable) and tip angle (if applicable). Does anything similar happen when you do a Show Path?
============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] http://www.highsteel.com ============================================= -----Original Message----- From: Michael Senack [mailto:[EMAIL PROTECTED]] Sent: Tuesday, December 05, 2000 8:21 AM To: '[EMAIL PROTECTED]' Subject: [mfg-smartcam] Show Cut help When I read in a milling .sh2 file in from SmartCAM V4.5 into Production Mill V11.5 and do a show cut I get the following error... Error: 2854 : Bad tool information. Simulation halted. When I click the OK button Dr. Watson appears and Production Mill closes down. I've tried the following... I edit each tool, and put in a .sh3 file for the cutter graphic. I save the file as a .pm4 and load it in and try show cut The Show Path works fine. Any ideas as to how to fix this? Regards, Michael Senack, X354 Your local friendly neighborhood CNC Programmer ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
