RE: [mfg-smartcam] Tool change position

[Bui, Peter]

Title: Untitled Stationery

Colin,

 

This is what my TMP look like, you would need to do a user command #V3=????,#V4=???? in your pm4 file.

Hope this help

 

Peter

 

 

@TOOLCHG
#IF(#U1=1)< *** TOOL CHANGE>
#RESET(#DWELL)
< #FXD> M05 M09
 #MOV G100 Z0
 #MOV X#V3 Y#V4
 G1#TOOL M06
 S#SPEED #SPNDL  #COOLNT F#FEED
 #MOV

-----Original Message-----
From: Williams, Colin [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, April 18, 2001 4:45 AM
To: Smartcam Forum (E-mail)
Subject: [mfg-smartcam] Tool change position

pturn 11.0:

 

I would like to be able to adjust my tool change position for each tool after it is done its operation. Right now it is going back to the same "x" & "z" values.

 

Thank you

 

Colin Williams



WABTEC CORPORATION CONFIDENTIALITY NOTE
The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited.