What does the output from your @ARC section look like? ============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] http://www.highsteel.com =============================================
-----Original Message----- From: Bui, Peter [mailto:[EMAIL PROTECTED]] Sent: Wednesday, February 28, 2001 11:49 PM To: Bui, Peter; SmartCAM List (E-mail) Subject: RE: [mfg-smartcam] Feed rate @ARC I forgot to mention I used this for @STPROF and it's worked fine. @STPROF #IF(#U9=1)< *** startprof> #IF(#U19=1)< G107 P#V3 L#V2> < #MOV>< X#XPOS>< Y#YPOS>< Z#ZPOS> Thanks -----Original Message----- From: Bui, Peter [mailto:[EMAIL PROTECTED]] Sent: Wednesday, February 28, 2001 7:27 PM To: SmartCAM List (E-mail) Subject: [mfg-smartcam] Feed rate @ARC I try to add this to my .tmp file so that I could program different feedrate @ARC, but it doesn't seem to work, is any body know why? To use this I would program a user command " #U1=1,#V1=20 " so #V1 will be = F20 @ARC #IF(#U9=1)< *** arc> #IF(#U1=1)< F#V1> < #PLANE>< #MOV>< X#XPOS>< Y#YPOS> I#XCTR J#YCTR #IF(#U1=1)#RESET(#FEED) Peter Bui CRANE ELDEC Corporation Phone: (425) 743-1313 Ext. 8758 FAX: (425) 743-8549 Email: [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> Web Page: www.ELDEC.com <http://www.ELDEC.com> ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
