you can explode to a polyline and cutter comp it but it will output lines.
thanks bill
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Wednesday, February 28, 2001 9:04 AM
Subject: [mfg-smartcam] re: threadmilling
> I am able to get the code generator to output the helix with cutter
comp --
> my problem is while creating the helix I have to reduce the helical radius
in
> relation to the diameter threadmill I am using. Changing to a different
dia
> threadmill from that which the program was created can only be adjusted in
> the control at runtime. I am trying to find a way to make these changes
> while keeping the comp in the control to a minimum to reduce the risk of
> error.
>
> Any suggestions would be helpful
>
> Derrick
> ======================================================================
> To find out more about this mailing list including how to unsubscribe,
> send the message "info mfg-smartcam" to [EMAIL PROTECTED]
> ======================================================================
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
