To exit with out any additional prompts. Create a label at the end of your macro @endmac or something like that then use a goto(endmac) inside the if test. That will take you to the end of the macro.
David Working on converting my SC 4.5 macros to SC 11.5 mcl files. So far so good... The problem I'm having with this mcl file is at the end, where I prompt for the XS= and YS= co-ordinates. In the SC 4.5 mac file all I had to do to end the macro was hit the Esc key. How do I accomplish this in the above mcl without adding any extra prompts to carry on or exiting? Regards, Michael Senack, X354 Your local friendly neighborhood CNC Programmer ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
