Alan,
We use Muti-DNC. It allows an operator at the machine to call out any nc
program he needs, without anybody's assistance. He just sends in a small
program from the control, ( requesting a specific nc program ), to the pc
in the office. Then sets up the control to receive the program. Within a few
seconds the pc from the office sends out the requested program. We use it
for Fanuc controllers. But they have a list of several different controllers
that they can communicate with. Check them out at....
http://www.multi-dnc.com/indexmulti.html
I believe they have a demo available also.
I had a little trouble when I upgraded computers. With the help of the free
technical support, and from this forum, I got that solved. Thanks to all
that replied from this very informative forum.
b rider
Alan wrote:
> I am looking for suitable software to allow us to down and upload
> program files between a PC (Win 95b) and our Mazak (M1, M32,
> T2, T3, T32-2) and Heidenhain TNC 415b controllers. We are only
> wanting to transfer the files to the PC for storage and back up, ie
> not for drip feed nor editing etc.
> What are you using and what are your comments?
>
> Regards
> Alan Gordon
> Track Industries Ltd
> 26 Wickham Street
> P O Box 19 543
> Christchurch
> New Zealand
> fax +64 3 384 9767
> Ph +64 3 384 4161
> ======================================================================
> To find out more about this mailing list including how to unsubscribe,
> send the message "info mfg-smartcam" to [EMAIL PROTECTED]
> ======================================================================
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
