RE: [mfg-smartcam] Cutter comp

[Greg Smith]

Vance Just a thought... I have done this by starting the cut above the pocket/slot.  Then, move down in Z. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Vance Qualls Sent: Tuesday, December 04, 2001 9:25 AM To: [EMAIL PROTECTED] Subject: [mfg-smartcam] Cutter comp How can I get SmartCam 11.5 Production Milling to output code with cutter comp to initiate before the first move in Z before starting a profile.  For example; entering a pocket which is not much bigger than the diameter of the end mill.  (Using a Haas VF-0 vertical machining center) Can I do this in Machine define, or is there an edit in the .tmp file I can make?