Thanks that way is simpler then the one I did. What I did was save the .PCB file as a .PCS and modified the first like a so...
PANEL "Shims" "" -1 -1 3 <--- changed this from 2 to 3 ACTION " Cut Stack CDC Left " "w:\mcl\shimpnch.mcl" 2 1 ACTION " Cut Off Stack " "w:\mcl\shimoff.mcl" 44 1 ACTION " Cut Hole(s) " "w:\mcl\shimhole.mcl" 2 2 ACTION " End Shim " "w:\mcl\shimend.mcl" 61 1 ACTION " Cut Stack CDC Right " "w:\mcl\shimcwph.mcl" 22 1 ACTION " Get Next Stack " "w:\mcl\shimnext.mcl" 44 2 ACTION " Cut Internal Pocket " "w:\mcl\shimpock.mcl" 22 2 ACTION " Graphics On " "w:\mcl\gron.mcl" 61 2 Thanks -----Original Message----- From: Pete Ruehle [mailto:[EMAIL PROTECTED]] Sent: Wednesday, February 13, 2002 2:12 PM To: Michael Senack; '[EMAIL PROTECTED]' Subject: RE: [mfg-smartcam] Resizing a CTK panel Michael, Open the pcb file in CTK, in the resources menu, click on properties. Under "configurable height", increase the number of lines. Pete -----Original Message----- From: Michael Senack [mailto:[EMAIL PROTECTED]] Sent: Wednesday, February 13, 2002 2:01 PM To: '[EMAIL PROTECTED]' Subject: [mfg-smartcam] Resizing a CTK panel How or should I say, can you resize a CTK panel? I made one up which has two lines for my tokens. Now I've run out of room and would like an additional line to add more tokens. Regards, Michael Senack ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
