Leonard, Are you programming in incremental? SmartCAM has always had problems with incremental programming. If you are, try absolute to see if this takes care of the problem.
John W. Kanney Automated Solutions, Inc. (540) 949-7703 ----- Original Message ----- From: "Leonard Lane" <[EMAIL PROTECTED]> To: "Smart Cam User Group (E-mail)" <[EMAIL PROTECTED]> Sent: Friday, February 15, 2002 6:56 AM Subject: [mfg-smartcam] Weird problem > Here's a problem. Maybe someone has seen it? With Advanced Fab 11.1 we > generated a large sheet of plate with lots of 3.75 holes burnt in it. > Everything looked good on the show path run. When I processed code and they > dry ran it on the machine there were randomly scattered bad lines of code. > Here is a sample: > > N110 G03 X-0.010 Y0.0 I-1.88 J0.0 > It should have read: > N110 G03 X0.0 Y0.0 I-1.88 J0.0 > > I did a search and replace in Edit Plus replacing all X-0.01 with X0.0 and > it ran OK. > > Out of about 50 holes about 10 lines were like this. The weird thing was all > the holes were clones of the first but the first one in the code was bad and > second copy was OK. > > Any suggestions? > > Thanks, > Leonard Lane > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
