We have three up and running for over a year now, and in the process of
adding a fourth. Two Warner Swasey lathes and soon to be two Cincinnati
lathes. The touch screen takes a bit to get use too, and it is fun to add
functionally "buttons" to the control.
Robert Fultz
Aurora Pump
"Dave Hayden"
<dhayden@Elliott-Turb To:
"'[EMAIL PROTECTED]'"
o.com> <[EMAIL PROTECTED]>
Sent by: cc:
owner-mfg-smartcam@lo Subject: [mfg-smartcam] Do any of
you have experience with
ki.sdrc.com OpenCNC
01/18/2002 06:49 AM
This is off topic. Lately we have been looking at MDSI's OpenCNC control
as a
retro-fit for our older machines with GE550, GE100 and AB7360 controls.
Does anyone out there have any experience with this control that you would
be
willing to comment on?
David Hayden
Elliott Turbomachinery
Jeannette, PA 15644
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
