Stephen; what I do and is very quick once I got used to it, is, group that step
after you create the geometry, and using "Toolpath Property Change" select the
offset you want, then move the geometry in the proper direction of your TNR
amount.
It sounds like a lot, but it's routine for me and fairly quick.
Regards; Randall McEachern
CNC Programmer,
Curtiss Wright Flow Control,
Farris Engineering.
Brantford, On.
N3T 5T3
(519) 756-4800 ext 241
[EMAIL PROTECTED]
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
