Fred, Thanks for the info. I'm having two problems (macros). The first has to do with decimal variables. If I establish the variable and a value first, as with a ctk dialog or panel and then launch the macro, the variable is decimal. However, if I launch the macro and enter a value at the prompt when the variable is first encountered, it sometimes ends up being a string type.
The second problem is that F_WRITE does not recognize the variable unless I establish it at the beginning or before the macro is launched. It will not recognize it if I run the macro and enter a value when prompted. So how do I get around this without using ctk? Do I have to open the mcl and enter all the variable values at the start of the macro? I tried #decvar=0 but then I had to clear it immediately afterwards with #decvar=1000000. I was then prompted for the value during macro execution but as before, F_WRITE didn't pick it up. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Thursday, May 23, 2002 2:02 PM To: [EMAIL PROTECTED] Subject: RE: [mfg-smartcam] declaring variables In a template file it's @DECLARE #DEC #DecVar #STR #StrVar #INT #IntVar In a macro file decimal is the default declaration with string and inter variables having unique declarations. STRING:#StrVar INTEGER:#IntVar If you need to establish a decimal variable beforehand, such as with the F_READ and F_WRITE commands, try this: #DecVar=0 That will create a decimal variable as long as the name is previously unused otherwise. On some occasions I've had to clear specific variables and re-declare them to insure they are the proper type. VAR_REMOVE[VN="DecVar"] #DecVar=0 -----Original Message----- From: Pete Ruehle [mailto:[EMAIL PROTECTED]] Sent: Thursday, May 23, 2002 1:45 PM To: 'SmartCam Forum' Subject: [mfg-smartcam] declaring variables What is the format for declaring a decimal variable? ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
