Hey guys,
I need some help w/ the Rgh. Turning Cycle.
I am looking for a way to have the Full depth of cut on the first
roughing pass.
If the pass depth is not evenly distributed, the first pass is
smaller then the rest, usually just a light skim cut.
We would like the last pass to be the smallest, I believe older
versions (we run 11.5) produced code this way.
Thank you for any help,
R. W. Eplett
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
