I did some thread milling a couple of weeks back. All I did was program it to the center of my tool, then added the cutter comp after I coded it. Depending on the controller you should be able to do this too.
Dean -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Wednesday, July 17, 2002 8:06 AM To: [EMAIL PROTECTED] Subject: RE: [mfg-smartcam] How do I find out about thread milling in the archive Try here: http://www.enteract.com/~kdgrills/smartcam-archive/index.shtml ============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] http://www.highsteel.com ============================================= -----Original Message----- From: Donald Stockham [mailto:[EMAIL PROTECTED]] Sent: Tuesday, July 16, 2002 3:28 PM To: [EMAIL PROTECTED] Subject: [mfg-smartcam] How do I find out about thread milling in the archive I would rather look in the archive to see how to use comp with thread mill than waste anyone's time with the same stuff different day again. thank you, Don ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
