Couldn't you create a workplane on three points that you would consider the "top", then View Angle or Dynamic View to that plane? Then you could name the view for reuse.
- John ----- Original Message ----- From: "Inthasane, Jay" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Tuesday, October 01, 2002 2:30 PM Subject: RE: [mfg-smartcam] Smartcam view? > Tom, > > Is there a way we can translate and rotate from one view to another in > Smartcam? > Cause I got this part that came in at a weird view and I like to translate > and rotate it to a top view. > > Thank you, > Jay > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] > Sent: Monday, September 30, 2002 9:11 PM > To: undisclosed-recipients > Subject: Re: [mfg-smartcam] Smartcam view? > > > Jay, > > If I understand your question; > > Select All (middle mouse button or group pallet) > Edit, > Transform, > Rotate (check suppress planes), > Rotate the work piece to the right orientation, > Move (no copies, move to where you want it i.e. "xyz zero"), > View , Top > View, Full > View, Name View > "Top" or "Top Full" > > Tom > > [EMAIL PROTECTED] writes: > > > > > All, > How can I translate a part that came in at a weird view and translate it to > tool plane view a top view? > Thanks in advance, > Jay > ================================ > > > > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
