Fred, Yes, I group the elements, go to Property Change, Toolpath, and set Clearance to No. I guess it's the cg forcing it, yes?
Regards, Pete -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Friday, October 11, 2002 7:24 AM To: [EMAIL PROTECTED] Subject: RE: [mfg-smartcam] rapid to clearance plane Are you turning off the clearance for the element both before and after the rapid move? ============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] http://www.highsteel.com ============================================= -----Original Message----- From: Pete Ruehle [mailto:[EMAIL PROTECTED]] Sent: Thursday, October 10, 2002 4:45 PM To: 'SmartCam Forum' Subject: [mfg-smartcam] rapid to clearance plane What method(s) can I use to prevent an end mill from retracting to the clearance plane before a rapid (G0) move? I've tried turning off clearance but I think the cg is forcing it. Thanks, Pete ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
