Michael, Go here: http://hometown.aol.com/gcodemcode/index.htm
This site has a nesting program. I have not used it personally, but from the description, looks like it might do the job. Eric Michael Senack wrote: > Speaking of nesting, is there a product out there > that is a good substitute for SC for nesting? > We nest die sections in 5" x 8" carbide die > section blocks. Depending on the orders being > placed we can nest anywhere from 4 to 12 die > sections per block. This is all done manually, > and it is the most time consuming part of the > process. The macro capability of SC really > shines when it comes time to program the die > section blocks after the nested layout is complete. > > Regards, > Michael Senack > > -----Original Message----- > From: Dean A. Scott [mailto:[EMAIL PROTECTED]] > Sent: Friday, October 18, 2002 9:45 AM > To: [EMAIL PROTECTED] > Subject: RE: [mfg-smartcam] Trumpf > > Yes, we are. We have 1 trumpf fabricator. We do nesting and everything in > smartcam. SC's not good for nesting!!! > > Dean > > -----Original Message----- > From: Greg King [mailto:[EMAIL PROTECTED]] > Sent: Friday, October 18, 2002 9:42 AM > To: [EMAIL PROTECTED] > Subject: [mfg-smartcam] Trumpf > > > Any users still programming Trumpf's with SmartCam? > > > > Greg King > > Group Leader > > Manufacturing Services > > Rittal Corporation > > Phone: 937-629-2485 > > Fax: 937-390-7341 > > > > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== -- Eric K. McKell, PE Assoc. Professor & Program Coordinator, MET Western Washington University Engineering Technology Department 516 High ST., ET 206 Bellingham, WA 98225-9086 office (360) 650-7931 fax (360) 650-4847 [EMAIL PROTECTED] ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
