Apparently SMF question #21 suppresses output moves of less than the assigned value and does not round the value to an the nearest even increment.
============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> http://www.highsteel.com <http://www.highsteel.com/> ============================================= -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Wednesday, September 25, 2002 6:15 PM To: [EMAIL PROTECTED] Subject: [mfg-smartcam] G-code output Hi all, When smf question #21 is set to .0005" the g-code should post in .0005" increments. Yet when I post, my g-code is still being produced with .0001" increments. Can anyone help with this? Am I missing an additional setting somewhere? I need to try .0005" increments to trouble shoot a re-occurring error in our Proto Trak MX2 toolroom mill controls. Thanks in advance. Chris Kocourek Tool Design Engineer FLEXTRONICS
<<attachment: coloerd_vees.bmp>>
