The correct default file would be "dwg_i_mm.set". You should not be getting Watsons by choosing the wrong file. It may be due to the version of AutoCAD that was used. The development of the Cam Connection was halted around Acad R14. There may also be some elements in the Acad file structure (blocks, etc...) that the Cam Connection can't handle.
================================================== Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> http://www.highsteel.com <http://www.highsteel.com/> ================================================== -----Original Message----- From: Bob Manganello [mailto:[EMAIL PROTECTED]] Sent: Thursday, February 13, 2003 7:38 AM To: SCQUEST (E-mail) Subject: [mfg-smartcam] Simple import question I need to import a metric .dwg (autocad) drawing into Adv. Milling version 11.5. What setup file do I need to use? My default is C:\SM9\CAMCON\dwg_i_in.set When I try to use it, Dr. Watson shows up and then I get the Import was unsuccessful message. I did try to use some of the other setup files without any luck. Does it matter if the drawing was created in AutoCad Lite or all out AutoCad? Thanks in advance, Robert Manganello K.B.A. North America York, Pa. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
