Hi guys, Recently had the following problem. I used WALL OFFSET on a Polyline to create a roughing pass, this created a Polyline with over 6,000 points. The code came out with a similar number of lines. Tried altering SMF file questions 21, 86 & 87 to no avail.
In the end I put the following at the start of my TMP file LINE section:- #IF(#LNLEN<=.01)<#UPDATE,#XPOS,#YPOS)> #IF(#LNLEN<=.01)<#EXIT> (The code is in mm). This shortened the code to an acceptable 500 lines or so but have a feeling this isn't the right way to do it! What is the correct way to shorten the code? Regards, Bill in the UK. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
