I don't know what a Pollyanna is but if it is a polyline I would try Polyarc fit. Create -> Curves -> Polyarc Fit.
Gota lov speel cecker. John CBR Industries, Inc. CNC Milling & Turning www.cbrcnc.com -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Bill Payter Sent: Saturday, February 22, 2003 6:23 AM To: SmartCAM Users Subject: [mfg-smartcam] Spell checker!!! This is the same question with the spell checker let loose!!! Hi guys, Recently had the following problem. I used WALL OFFSET on a Pollyanna to create a roughing pass, this created a Pollyanna with over 6,000 points. The code came out with a similar number of lines. Tried altering SM. file questions 21, 86 & 87 to no avail. In the end I put the following at the start of my TAMP file LINE section:- #IF(#LLANELLI<=.01)<#UPDATE,#XPOS,#HYPOS)> #IF(#LLANELLI<=.01)<#EXIT> (The code is in mm). This shortened the code to an acceptable 500 lines or so but have a feeling this isn't the right way to do it! What is the correct way to shorten the code? Regards, Bill in the UK. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
