Thank you for your help.
I am trying to automatically reduce the feedrate on arc depending on the tool � used. For example. <2 x Dia feed * 0.75 <1.5 x Dia feed *0.85 < 1.25 Dia. feed * 0.10 Thank you for your help Gary ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Thursday, June 12, 2003 6:43 AM Subject: RE: [mfg-smartcam] Post help needed please > > > I was too busy looking at the syntax of the logic expression and was not > paying attention to the content. > > While the following syntax is correct: > > #IF(#ARAD<2,#AND#ARAD>2)<#EVAL(#FEED=#FEED*0.1)> > > the logic will NEVER result in a true condition because #ARAD cannot be both > less than and greater than 2 at the same time. > > How do you want the arc radii to effect the feed rate? > > ================================================== > Fred Lauzus, CAM Programming Coordinator > High Steel Structures, Incorporated > mailto:[EMAIL PROTECTED] http://www.highsteel.com > ================================================== > > > > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > Sent: Wednesday, June 11, 2003 2:57 PM > To: [EMAIL PROTECTED] > Subject: RE: [mfg-smartcam] Post help needed please > > > > Try this: > > @ARC > #IF(#ARAD<2,#AND#ARAD>2)<#EVAL(#FEED=#FEED*0.1)> > < #PLANE> #MOV X#XPOS Y#YPOS I#XCTR J#YCTR< F#FEED> > #RESET(#FEED) > > > ================================================== > Fred Lauzus, CAM Programming Coordinator > High Steel Structures, Incorporated > mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> > http://www.highsteel.com <http://www.highsteel.com/> > ================================================== > > > -----Original Message----- > From: gary [mailto:[EMAIL PROTECTED] > Sent: Wednesday, June 11, 2003 2:31 PM > To: Smartcam Users Group (E-mail) > Subject: [mfg-smartcam] Post help needed please > > > I am trying to reduce the feedrate on arcs if a arc radius falls between a > certain range. Could someone please take a look and correct my first > attempt. > > > > @ARC > #EVAL(#ARAD<2,#AND#ARAD>2)#FEED=#FEED*0.1> > < #PLANE> #MOV X#XPOS Y#YPOS I#XCTR J#YCTR< F#FEED> > #RESET(#FEED) > > > Thank you in advance > > Regards, > Gary > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
