Sorry Kevin, I hit reply instead of reply to all.
-----Original Message-----
From: Stannard, Rick
Sent: Friday, July 11, 2003 1:43 PM
To: 'Kevin Clark'
Subject: RE: [mfg-smartcam] TMP questions
If I understand you correctly, you want a blank space to show up in your program?
If so, you must have a blank space followed with 2 slashes in your tmp file at the point of where you want the blank space.
See example below.
O#FILE
//BLANK SPACE
( #part )
( DWG# #S0 REV# #S1 )
( #matl )
( #DATE #name )
( START REF U0 W-#S3 Y0)
//BLANK SPACE
( COLLET CLOSE GO TO Z0 )
//BLANK SPACE
#ONBLKG20M97
Rick
-----Original Message-----
From: Kevin Clark [mailto:[EMAIL PROTECTED]]
Sent: Friday, July 11, 2003 12:19 PM
To: Benz H. Babecki; Smartcam forum
Subject: Re: [mfg-smartcam] TMP questions
At 02:30 PM 7/11/2003 -0400, Benz H. Babecki wrote:
>This is progressing nicely, Thank you all.
>I do however have 2 more questions concerning the template file.
>1>Is there a way to force a linefeed/carriage return so that I may get a
>blank line between tools?
just do a carriage return in your @TOOLCHG
This should leave a blank line after the (MSG,)
>2>We only have 32 tool offsets. We like to make the "D" comp 16 more than
>the length offset. A little coding hint would be deeply appreciated.
In your job file go through all your steps and edit process step Doff put
this in the box JOS(tl_num)+16
>Thanks again and have a great weekend.
>
Hope this helps,
Kevin Clark
Programmer
Abbott Workholding Inc.
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
