im trying to export some of my sc files as dxf files to see how another system will
accept them.they export fine but the toolpaths are also exporting as geometry.under
one of the output settings there is a box that reads "convert toolpaths?=
i seem to get the same output wether i check this box or not.the only way ive been
sucessful at doing it was to delete all of the toolpaths and save the prog with only
geo,then export that one.is there an easier way?
thanks
mark
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
